Sturdy Built Zinc Plated Square 2,500 lb Ram Dropfoot Bolt-On Boat Trailer Jack

This corrosive-resistant square 2,500 lb boat trailer jack is an ideal bolt-on replacement for your marine boat trailer. The rust-resistant zinc-plated finish increases the durability and longevity of the jack, so you can get more bang for your buck. This jack is commonly seen on boat trailers with boats ranging from 20 to 30 feet and is sometimes mounted with two jacks on either side of the tongue to gain extra capacity and increase the stability of the trailer when not attached to the tow vehicle. The pre-welded mounting plate allows this jack to fit on trailer tongues 2" to 5" tall and up to 3" in width, and all mounting hardware you need is included, so you can mount the jack right out of the box!This square zinc-plated jack will fit a variety of different trailer and boat sizes and is a sturdy rust-resistant replacement for your old worn-out jack. The included drop-foot is suitable to use on hard ground and soft ground alike, with a 7 1/2" x 3 3/4" foot area. The jack also includes a greaseable zerk fitting so you can lubricate the gear housing when needed, and is covered by a 1-year warranty. Features- 2,500 lb capacity boat trailer jack- Zinc-Plated for Corrosion Resistance- Bolt-On jack includes mounting hardware- Includes grease fitting for greasing gear housingSpecifications- Fits frames 2" to 5" in height and up to 3" in width- Lift height from 7 1/4" to 22 5/8"- Drop foot measures 7 1/2" by 3 3/4"- 2,500 lb capacity- 1 Year Warranty