13 GPM 2 Stage Hydraulic Log Splitter Pump Hi/Lo Gear Pump For Log Splitter and Hydraulic System Power Units, Maximum pressure 3000 PSI Wood Splitter Pump

The 2-stage pump can give you faster cycle times and higher possible pressure with a small engine. Excellent for use on log splitters. 85% efficient. Suggested applications: Presses, Log Splitters, Clamping Units and CompactoSpecifications:New Hydraulic Log Splitter Pump 16 GPMShaft: ½"Inlet port: 150mmOutlet port: 230mmMinimum 8 HP or larger gas engine.For use with open center hydraulic systems onlyMaximum pressure: 3000 PSIBolt circle: 2.83in.4 holes spaced 2" on centerMounting hole diameter: 344inWoodruff key: 1/8inRotation is clockwiseThis 2 stage pump can give you much faster cycle times and higher possible pressures with a small engine. Excellent for use on log splitters. 85% efficient.The HI/LO section of the pump is all aluminum and the end plates are cast steel. Applications for the HI/LO pump are log splitters, presses etc where rapid movement of the cylinder at low pressure is required prior to automatically switching to the high pressure mode to meet load requirements.Packing Include:1 PC 16 GPM Hydraulic Log Splitter Pump

• [WIDE APPLICATION] This is a 2 stage hydraulic pump that gives you faster cycle times and higher pressures with a small engine. It is a new hydraulic log separator pump widely used in presses, log separators, clamping units and Compacto and any application where you need to extend the hydraulic cylinder. Strong stability, more assured to use.
• [PREMIUM MATERIAL] The HI/LO section of the hydraulic pump is all aluminum and the end plates are cast steel. It has the characteristics of heat resistance, high strength, low noise, high quality and long service life. The 2-stage hydraulic pump is compact and lightweight, making it easy to carry and operate.
• [SPECIFICATIONS] Package Include:1 PC 13 GPM Hydraulic Log Splitter Pump. Shaft: ½". Inlet port: 150mm. Outlet port: 230mm. Minimum 8 HP or larger gas engine. For use with open center hydraulic systems only. Maximum pressure: 3000 PSI. Bolt circle: 2.83in. 4 holes spaced 2" on center. Mounting hole diameter: 344in. Woodruff key: 1/8in. Rotation is clockwise.
• [HIGH EFFICIENCY] The applications of HI/LO pump are log separators, presses, etc. Before automatically switching to high pressure mode to meet the load requirements, it is only necessary to quickly move the cylinder under low pressure, shorten the cycle of each operation, greatly improve labor efficiency, and use Very convenient and fast.
• [QUALITY ASSURANCE] We have strict quality control system, our products are put into the market after rigorous testing. Please allow the slight color difference caused by the shooting light and 1-3cm error due to manual measurement, and make sure you do not mind before ordering.