Brady 104523 ToughStripe Nonabrasive Dot Shaped Floor Marking Tape, 3.5" Diameter, Yellow, Prespaced (Pack of 55 Per Roll)

To apply, you simply lay down the line like you would continuous tape, then peel off the transfer liner. The floor dots will be applied evenly spaced 18" apart, in a straight line - in seconds. 3.5" floor dots are available in red, green, blue, yellow, black and white. Superior durability, withstands forklift traffic without tearing or lifting, low-profile design minimizes tears and scratches from skids, pallet jacks, etc., made with rugged polyester and aggressive adhesive. Painless removal, does not chip and flake when being removed - comes off in one piece, clean removal without any unsightly adhesive residue or damage to the floor. High visibility, high-gloss surface shines like new paint, low profile minimizes debris build-up along the edges that occurs with thicker (extruded) floor marks, surface resists marks and smudges and cleans up like new. Dot shape. Brady B-514 is a surface printed polyester with a rigid, clear polyester overlaminate. Brady B-514 is used to mark aisles, passageways, storage locations, and point out safety equipment and exits. Brady B-514 exhibits a dry slip index of 1.0 when tested using an English XL Variable Incidence Tribometer per ASTM / ANSI F1679. B-514 exceeds safety standards for clean, dry non-slip surfaces per ANSI A1264.2-2006 and OSHA 1910.22. Permanent rubber based adhesive type. Not recommended for outdoor use. RoHS Compliant/Lead Free.

• Highly durable, easy to apply, easy to remove
• Come on pre-spaced rolls to make installation quick and easy
• Made of tough, resilient material so you can spend less time replacing damaged or worn tape, you can apply them once, and be done
• Can be easily removed without damaging the floor or leaving residue
• Offer the same visibility as painted floor markings, but cost much less